ABERTAX® CLS
Capacitive Battery Electrolyte Level Sensor
Installation Video
The following CLS products are available
The ABERTAX® CLS - with external LED and sense cover is our version for providing the means of monitoring the electrolyte level of the battery on the dashboard of the vehicle. The external LED housing has a lens cover which gives a steady GREEN signal, when electrolyte level is above the cell plates, and turning to flashing RED, when the electrolyte level is below the cell plates. Please follow the attached installation instruction. To install the CLS, you either drill a hole in the cell lid and use the Gauge Gauard version for sealing and measuring the probe length, or you make use of the air agitation hole. For this installation you need the O-ring version.
- External LED
- Integrated level probe
- Gauge Guard or O-Ring
- Various connector types
- External LED with sense cover
-
Parameters
- Input / Supply Voltage :
- 12V (6 x 2V cells)
- Max. Operating Volt. (12VDC nom.) :
- 18VDC
- Min. Operating Volt. (12VDC nom.) :
- 10VDC
- Current Consumption 12VDC :
- <20mA
- Operational Temp. Range :
- -30°C to +70°C
- Temperature Sensor Range :
- n/a
- Relative Humidity in Operation :
- 95% no dew
- Relative Altitude :
- Up to 2000m ASL
- Protection class :
- IP65
- Weight w. stand. version approx. :
- 60g
- Diameter probe (including seal) :
- 5mm
- Diameter hole for Gauge Guard :
- 10mm (M10 drill)
- Dim. Sensor head :
- 30mm diameter, 20mm heights
- Dim. Sensor bet. supply cable :
- 27mm between cable grommets in housing. 31mm diameter of circular housing
- Product Catalogue :
- Download